The acorn names and logos are trademarks owned by acorn stair lifts inc.
Acorn stair lift remote not working.
You ve probably done so already but if not check or double check the on off switch on the stairlift.
Both lift remotes have the same code and both operate at the same time.
If your stairlift is not working making a strange noise or won t stop beeping there a few things you can check.
The problem is there is another acorn stair lift nearby.
Turn the power key to the off position and then back on.
My remote control doesn t work.
Opened the remote battery cover and there is a dip switch 1 is up and 2 is down.
If you have checked these things and your stairlift continues to beep switch your stairlift off and call us or your local dealer.
Check and replace the batteries if necessary.
If your stairlift still does not move.
Here are the most common codes for the acorn 120 and 130 stair lifts.
Call us or your local.
The stairlift can still be used in the meantime by operating it with the remote control.
If the switch is in the off position turn it to switch the stairlift on.
Stair lifts have many features to keep you safe and operational at the same time.
If they are both cut then the remote is set for channel 4.
Check the stairlift is parked correctly at the top or bottom of the stairs.
It is important to note the codes flash in sequence of a letter then number.
Should the stairlift still operate when you use either the remote control or the call switch on the wall but not the joystick then you will need to call an engineer.
Why is my stairlift not working.
Sometimes the stairlift joystick may be faulty.
My stairlift won t move.
Simple enough i make them both up and neither stair lift responds.
Now you need to open up the front compartment on your stairlift and look at the transceiver board which is the green board attached to the bottom of the blue circuit board.
My automatic swivel doesn t work.
This picture is the main disconnect or battery isolation switch for the acorn 130 stairlift model.
If your lift stops working the codes on your lift can tell you what the problem is.
Just installed an acorn 120 stair lift at my parents home.
The power light should be illuminated to show it is on.
Move and hold the control in the direction of travel for a few seconds after which the stairlift should start.
Take a look at our stair lift quick check video below.
