Pull positioning on plates wider than 4 handing required.
Ada door pull height.
About staggered pulls levers and ada design.
1220 mm above finished floor.
The maximum high reach is reduced to 46 when the reach over an obstruction is deeper than 10 to a maximum of 24.
The height of the door handle must be between a minimum of 34 and a maximum of 48.
Hardware required for accessible door passage shall be mounted no higher than 48 in.
Door pulls do not always have to lock into header ceiling.
Is designed to have full height inside the office while offering shortened height outside the office door corridor.
This provides a clearance of 10 inches or more from the finished floor required by code.
Obstructions at side reaches are limited to a height of 34.
Front approaches to pull side of swinging doors shall have maneuvering space that extends from the hinge side of the door to 18 inches 455 mm minimum 24 inches 610 mm preferred beyond the latch side of the door and 60 inches 1525 mm minimum perpendicular to the doorway.
Access doors or gates in.
Pull positioning on plates 4 or less in width.
Door hardware ada compliant locks exit devices handles pulls latches and other operable parts on doors shall comply operable parts of such hardware shall be 34 inches minimum and 48 inches maximum above the finish floor or ground.
This facilitates access since mobility aids including wheelchair footrests are sometimes used to push or prop open doors.
Door handles pulls latches locks and other operating devices shall be installed 34 inches 864 mm minimum and 48 inches 1219 mm maximum above the finished floor.
Door and gate surfaces 404 2 10 the bottom surface of doors and gates on the push side must be smooth to a height of at least 10.
Therefore when the handle ladder pull is installed there must be a clear distance from the glass surface to the inside of the pull surface of 2 1 2 or 64 5mm.
Pre existing locks most likely not applicable to new builds gates protecting pools spas and hot tubs are allowed to be a bit higher up to 54.
Door hardware mounting heights 2010 ada changes ibc 2009.
The staggered pull.
Click here for printable pdf version.
You should always check.
Ada door handle height requirement.
Recommended locations on door.
Locks used only for security purposes and not used for normal opera tion are permitted at any height.