To avoid injury make sure the spring is completely free of tension before removing.
Adjusting garage door tension springs.
How to adjust garage door tension.
If your garage door cable is at an angle or l.
This video will show you how to repair a mis aligned garage door cable.
The springs are located at the top inside part of the garage door.
Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel.
Garage door springs offset the weight of the door and allow it to open and close with ease.
Adjust the springs on both.
You need proper tension on a garage door to operate the door by hand or with an automatic opener.
The torsion spring helps the garage door open and close easily.
If the door was closing too quickly move the spring to the next higher hole on the bracket.
If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments.
There are two torsion springs at each side of the garage door.
You must release the tension on the garage door springs before attempting adjustment or replacement.
Open it just as wide as you can without hitting the garage door opener s stop bolt and place a clamp on the track on both sides to keep the door in.
If it was opening too quickly move it to the next lower hole.
A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem.
With an extension spring door the goal is to take all the tension off the door before you even think about touching a spring you can do this by opening the door all the way and propping it up with a ladder.
Adjusting an extension spring door.
How to safely adjust your garage door spring.
This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track.
This can make the other parts of the garage door last a much longer time.
This video applies t.